**** (flash four) Releaase the feed button Set to printer Defaults, in case above steps fail to calibrate try resetting the printer to factory defaults. Close lid and press the feed button once to position the label/tag to the beginning. When the printer completes and the light is solid green then open the printer to roll back the tags back onto the roll.
Reset zebra printer to factory defaults manual#
These steps should only be peformed if the Manual calibration does not work in step 1 or tags are switched between those with black bars and those with.Īny calibration will feed a few labels out to perform the calibration. When the Advance tab re-appears click Calibrate and the printer should perform the Calibration with the new settings.
Reset zebra printer to factory defaults driver#
To calibrate navigate to the Zebra DC420 driver in the Windows Printer folder and right click then choose Printing Preferences. Use the driver calibration method when the printer does not feed/print the labels properly or when you change from labels without a black bar printed on the labels to labels with a black bar (like the bell jewelry labels) anjd the manual claibration in step 1 does not work. The printer will feed one to four labels while calibrating. Standard Auto Media Calibration - The printer detects and sets media type and media length, and it adjusts the media sensors for optimal performance with the installed media (equivalent ZPL command ~JC ~JG). Status Light flash sequence for auto calibration Release the key after the specific number of flashes and before the next flash sequence starts to perform a task. The sequence starts at 1 flash and progresses upto 7 flashes. The green status LED will flash a number of times in sequence. With the printer power on and top cover closed, press and hold the Feed button for several seconds. If the printer initializes with the status light blinking green (pause mode), press the Feed button once to set the printer in Ready (to print) mode (light is solid green).ġ) Manual calibration via the Feed button located on the printer (see illustration below for feed button location) is recommended whenever the printer will not correctly auto calibrate/print onto a tag/label. Then, turn the printer power on if you have not already done so. Insert the label stock, label/tag print side facing up. Zebra offers two ways to calibrate the printer to the stock inserted.įirst. If this does not adjust the printing properly then the printer must be manually calibrated. If the label stops where it should then perform a test print and that is ok you are good to go. Once the light is solid green - Press feed button, wait till stock paper stops moving and press Feed button again. By default the printer attempts to auto calibrate to the label stock installed with the printer is turned on and while status light is becmes solid green. When switching stock in the printer insure the printer is turned off.
0 kommentar(er)
